Troubleshooting
Charging System

Symptom

Suspect area

Remedy

Charging warning indicator does not light with ignition switch "ON" and engine off.

Fuse blown

Check fuses

Light burned out

Replace light

Wiring connection loose

Tighten loose connection

Electronic voltage regulator

Disconnect the voltage regulator to see if light turns off. If light turns off, replace voltage regulator.

Charging warning indicator does not go out with engine running. (Battery requires frequent recharging)

Drive belt loose or worn

Adjust belt tension or replace belt

Battery cable loose, corroded or worn

Inspect cable connection, repair or replace cable

Electronic voltage regulator or alternator

Disconnect the voltage regulator or alternator to see if light turns off. If light turns off, replace voltage regulator.

Wiring

Repair or replace wiring

Overcharge

Electronic voltage regulator

Disconnect the voltage regulator to see if light turns off. If light turns off, replace voltage regulator.

Voltage sensing wire

Repair or replace wiring

Discharge

Drive belt loose or worn

Adjust belt tension or replace belt

Wiring connection loose or short circuit

Inspect wiring connection, repair or replace wiring

Electronic voltage regulator or alternator

Disconnect the voltage regulator or alternator to see if light turns off. If light turns off, replace voltage regulator.

Poor grounding

Inspect ground or repair

Worn battery

Replace battery

Starting System

Symptom

Suspect area

Remedy

Engine will not crank

Battery charge low

Charge or replace battery

Battery cables loose, corroded or worn out

Repair or replace cables

Transaxle range switch (Vehicle with automatic transaxle only)

Refer to TR group-automatic transaxle

Fuse blown

Replace fuse

Starter motor faulty

Replace

Ignition switch faulty

Replace

Engine cranks slowly

Battery charge low

Charge or replace battery

Battery cables loose, corroded or worn out

Repair or replace cables

Starter motor faulty

Replace

Starter keeps running

Starter motor

Replace

Ignition switch

Replace

Starter spins but engine will not crank

Short in wiring

Repair wiring

Pinion gear teeth broken or starter motor

Replace

Ring gear teeth broken

Replace fly wheel or torque converter

Preheating System

Symptom

Suspect Area

Remedy

Delayed starting, rough idling and white smoke emissions at low temperatures.

(These conditions disappear after the engine warms up sufficiently) 

Glow plug

Check the suspect area, or replace as required.

Glow plug relay

Glow plug plate

Glow plug fuse

ECM

Battery

Wiring connection

Engine Coolant Temperature Sensor (ECTS)

Ignition switch 

Glow lamp (integrated into cluster)

Яндекс.Метрика