3.
Remove the glow relay (A).
Turn ignition switch OFF and disconnect the negative (-) battery cable.
Remove the fuse box cover.
Remove the glow relay (A).
Using an ohmmeter, check that there is continuity between each terminal.
Terminal | Value | Measure | ||
30 - 87 | 1MΩ or Higher | If there is continuity, replace the relay. | ||
85 - 86 | continuity | If there is no continuity, replace the relay. | ||
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87.
Terminal | Continuity |
30 - 87 | Below 1Ω |
85 - 86 | Apply 12V |
If there is no continuity, replace the glow relay.
Install the glow relay relay.
Install the fuse box cover.
