1.
Install the jack to the edge of upper oil pan to support the engine.
note
Insert the rubber block between jack and oil pan.
Install the jack to the edge of upper oil pan to support the engine.
Insert the rubber block between jack and oil pan.
Disconnect the ground cable (A).
Tightening torque:
10.8 ~ 13.7N.m (1.1 ~ 1.4kgf.m, 8.0 ~ 10.1lb-ft)
Remove the engine mounting support bracket (A).
Tightening torque
Nut (B) :
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Bolt (C), Nuts (D) :
58.8 ~ 73.5N.m (6.0 ~ 7.5kgf.m, 43.4 ~ 54.2lb-ft)
Remove the engine mounting support bracket (E).
Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)
Installation is reverse order of removal.
Remove the roll rod bracket (A).
Tightening torque
Bolts (B):
49.0 ~ 63.7N.m ( 5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)
Nut (C):
107.9 ~ 127.5N.m (11.0 ~ 13.0kgf.m, 79.6 ~ 94.0lb-ft)
Remove the roll rod mounting support bracket (A).
Tightening torque :
49.0 ~ 68.6N.m ( 5.0 ~ 7.0kgf.m, 36.2 ~ 50.6lb-ft)
Installation is reverse order of removal.
Remove the air cleaner assembly.
(Refer to Intake and Exhaust System - "Air Cleaner")
Remove the ECM (Engine Control Module).
(Refer to Engine Control / Fuel System - "Engine Control Module (ECM)")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the engine room under cover.
(Refer to Engine And Transaxle Assembly - "Engine Room Under Cover")
Install the jack to the edge of transaxle.
Remove the service cover (A).
Remove the transaxle support bracket mounting bolt (A).
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the transaxle support mounting bracket (A).
Remove the transaxle mounting bracket (B).
Tightening torque :
63.7 ~ 83.4 N.m (6.5 ~ 8.5, 47.0 kgf.m ~ 61.5 Ib-ft)
Install in the reverse order of removal.
