3.
Remove the mounting bolt (B), and then remove the valve from the engine.
[Bank 1/Intake]
[Bank 1/Exhaust]
Turn ignition switch OFF.
Disconnect OCV connector.
Measure resistance between OCV terminals 1 and 2.
Check that the resistance is within the specification.
Specification : Refer to "Specification"
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the CVVT oil control valve connector (A).
Remove the mounting bolt (B), and then remove the valve from the engine.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Apply the engine oil to the valve O-ring.
Install in the reverse order of removal.
CVVT oil control valve mounting bolt :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
