3.
Remove the mounting nuts (B).
Turn ignition switch OFF.
Disconnect the accelerator position sensor connector.
Measure resistance between voltage supply terminal and ground terminal of APS1.
Measure resistance between voltage supply terminal and ground terminal of APS2.
Check that the resistance is within the specification.
Specification : Refer to Specification section.
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
Disconnect the accelerator position sensor connector (A).
Remove the mounting nuts (B).
Remove the accelerator pedal assembly from the vehicle.
Installation is reverse of removal.
Accelerator pedal module installation nut :
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module installation bolt :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
