4.
Remove the snap pin (A-2ea) and then removing the select cable (B) and shift cable (C).
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - " Air Cleaner)
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the ECM.
(Refer to Engine Control System - "ECM")
Remove the snap pin (A-2ea) and then removing the select cable (B) and shift cable (C).
Remove the control shaft assembly (A) after loosen the bolts.
Tightening torque :
19.6 ~ 26.5 N.m (2.0 ~ 2.7 kgf.m,14.5 ~ 19.5 lb-ft)
Install in the reverse order of removal.
When installing, set control shaft lever to neutral position.
When installing, apply the sealant as shown in the illustration.
Specified sealant : MS 721-40 or MS721-38
After installing, check to be sure that this part operates as designed at each range of transaxle side corresponding to each position of shift lever.
