Remove the under cover.
(Refer to Engine Mechanical System - "Engine room under cover")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.
Tightening torque :
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)
Replace the gasket before reinstalling the drain plug.
After the installation, start the engine and then check if there are any leakages from the drain plug.
Remove the wiring mounting bolt (A) or clip.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Disconnect the air breather hose (A) from the valve body cover.
Remove the valve body cover (A).
Tightening torque :
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)
Replace the gasket (B) before reinstalling the valve body cover.
After the installation, start the engine and then check if there are any leakages from the valve body cover.
Disconnect the oil temperature sensor (A) and solenoid valve connector (B) from the valve body.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Check for the looseness, poor connection, bending, corrosion, contamination, deterioration, or damage before reinstalling the solenoid valve connector.
Remove the valve body assembly (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Reassembly and disassembly procedures of the valve body assembly, refer to overhaul manual.
To install, reverse the removal procedure.
Check fluid level, after filling the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
Reset the automatic transaxle adaptive values using the GDS.
Perform the TCM adaptive values learning procedure.
(Refer to Automatic Transaxle Control System - "Repair procedures")
