2.
Pull the knob (A) in the direction of "F" and remove the knob.
Disconnect a boots from the console upper cover.
Pull the knob (A) in the direction of "F" and remove the knob.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
Disconnect the connector (A) from the shift lever.
Disconnect the wiring mounting clips (B).
Disconnect the control cable.
Disconnect the cable holer (A) from the shift lever.
Disconnect the cable bracket from the shift lever after pushing the lock.
Remove the bolts and then shift lever assembly (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Remove the P position switch mounting bracket (A).
Disconnect the P position switch (B) and shift lock solenoid (A).
Disconnect the manual mode switch housing (A).
Disconnect the main connector (A) from the shift lever.
P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).
Remove the mounting bracket (A) of terminals from the main connector.
Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
Record the location of the wiring colors before disconnecting the terminals.
▶Connector information
3. Shift lock solenoid (-)
4. Shift lock solenoid (+)
5. Ground
6. Sports mode down switch
7. Sports mode select switch
8. Sports mode up switch
9. P (Parking) position switch (+)
10. P (Parking) position switch (-)
Disconnect a boots from the console upper cover.
Pull the knob (A) in the direction of "F" and remove the knob.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
Disconnect the connector (A) from the shift lever.
Disconnect the wiring mounting clips (B).
Disconnect the control cable.
Disconnect the cable holer (1) from the shift lever.
Disconnect the cable bracket (3) from the shift lever after pushing the lock (2).
Remove the bolts and then shift lever assembly (A).
Tightening torque :
9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
Remove the P position switch mounting bracket (A).
Disconnect the P position switch (B) and shift lock solenoid (A).
Disconnect the manual mode switch housing (A).
Disconnect the main connector (A) from the shift lever.
P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).
Remove the mounting bracket (A) of terminals from the main connector.
Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
Record the location of the wiring colors before disconnecting the terminals.
▶Connector information
3. Shift lock solenoid (-)
4. Shift lock solenoid (+)
5. Ground
6. Sports mode down switch
7. Sports mode select switch
8. Sports mode up switch
9. P (Parking) position switch (+)
10. P (Parking) position switch (-)
To install, reverse the removal procedure.
Install the cable after placing the shift lever and the manual control lever in the N position.
