1.
Using a screwdriver or remover, remove the rear combination lamp cover (A).
Put on gloves to protect your hands.
When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Using a screwdriver or remover, remove the rear combination lamp cover (A).
After loosening the mounting screws, then remove the rear combination lamp (A).
Disconnect the rear combination lamp connector (A).
Loosen the rear bumper lower mounting clips.
Loosen the mounting bolts.
Disconnect the rear bumper main connector (A).
After loosening the rear bumper side's mounting screws, then disconnect the side's.
Loosen the rear bumper upper mounting clip.
Remove the rear bumper cover (A).
Install in the reverse order of removal.
Make sure the connector is plugged in properly.
Replace any damaged clips.
