3.
Remove the smart key unit (B) after loosening the mounting bolts(2EA) and disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the glove box.
(Refer to Body - "Glove Box Housing")
Remove the smart key unit (B) after loosening the mounting bolts(2EA) and disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the console rear complete assembly.
(Refer to Body - "Floor Console Assembly")
Remove the interior 1 antenna (B) after loosening the mounting nuts (2EA) and disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the rear transvers trim.
(Refer to Body - "Trunk Trim")
Remove the interior 2 antenna (B) after loosening the mounting nuts(2EA) and disconnecting the connector (A).
Disconnect the negative (-) battery terminal.
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
Disconnect the antenna connector (A) on the center of rear bumper.
After loosening the screws (2EA), remove the exterior bumper antenna (B).
Disconnect the negative (-) battery terminal.
Remove the front left wheel guide.
Disconnect the connector (A) then remove the buzzer (B).
Disconnect the negative (-) battery terminal.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
Remove the door outside handle cover (A) after seperating the plug hole (B) from the door and loosening the mounting bolt.
Remove the outside handle (A) by sliding it rearward.
Disconnect the front door outside handle connector (A) and then remove the wiring mounting clips.
Disconnect the negative (-) battery terminal.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
Remove the tailgate garnish (A) disconnecting the connectors (B) and loosenng the mounting nuts.
Remove the tailgate switch (A) after seperating the license lamp wiring.
Refer to Smart Key System - "Smart Key Diagnostic"
Refer to Smart Key System - "Smart Key Diagnostic"
Refer to Smart Key System - "Smart Key Diagnostic"
Remove the front door trim.
(Refer to Body - "Front Door Trim")
Disconnect the front door outside handle connector.
Check for continuity between terminals No 1 and No 3.
No | Description |
1 | Door antenna 1 |
2 | Door lock/unlock button 1 |
3 | Door antenna 2 |
4 | Door lock/unlock button 2 |
Check for continuity between the tailgate switch terminals.
If continuity is not specified, inspect the switch
Install the smart key unit.
Install the smart key unit mounting bolts and connect the connector.
Install the driver side crash pad lower panel.
Install the negative (-) battery terminal and check the smart key system.
Install the interior 1 antenna.
Install the console rear complete assembly.
Install the negative (-) battery terminal and check the smart key system.
Install the interior 2 antenna.
Install the rear transvers trim.
Install the negative (-) battery terminal and check the smart key system.
Install the exterior bumper antenna.
Install the rear bumper cover.
Install the negative (-) battery terminal and check the smart key system.
Install the buzzer.
Install the front left wheel guide.
Install the negative (-) battery terminal and check the smart key system.
Install the outside handle.
Install the door trim.
Install the negative (-) battery terminal and check the smart key system.
Install the tailgate switch.
Install the tailgate garnish.
Install the tailgate trim.
Install the negative (-) battery terminal and check the smart key system.
