2.
Disconnect the PCB block connectors (A).
Disconnect the negative (-) battery terminal.
Disconnect the PCB block connectors (A).
Put up the PCB block (A) after push 6 hooks (B) in the block assembly.
Be sure there is no play in the fuse holders, and that the fuses are held securely.
Are the fuse capacities for each circuit correct?
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.
Multi fuse is needed to replace in the mass when it damaged only one fuse.
When replace the multi fuse, refer to the "Engine compartment - component location" diagram exactly.
Use the multi fuse capacities for each circuit correctly.
