Remove the front door trim.
(Refer to Body - "Front Door Trim")
Remove the front door module.
(Refer to Body - "Front Door Module")
Disconnect the connectors from the actuator.
NO | Pin information | |
LH | RH | |
1 | Motor 1 | AJAR Switch |
2 | Motor 2 | COM |
3 | - | Lock / UnLock switch |
4 | Key Unlock switch | Key Lock switch |
5 | Key Lock switch | Key Unlock switch |
6 | Lock / UnLock switch | - |
7 | COM | Motor 2 |
8 | AJAR Switch | Motor 1 |
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
Remove the rear latch.
(Refer to Body - "Rear Door Latch")
Disconnect the connectors from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
Disconnect the 4P connector from the actuator.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
Disconnect the switch connector.
Check for continuity between the terminals in each switch position according to the table.
Disconnect the connector (A) and bolts from the hood switch.
Check for continuity between the terminals and ground according to the table.
Remove the burglar horn (A) after removing a bolt and disconnect the 2P connector from the burglar horn.
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.
The burglar horn should sound. If the burglar horn fails to sound replace it.
