1.
Operate the wiper switch to check for continuity between wiper motor terminals
No | Description |
1 | Speed |
2 | GND |
3 | B (+) |
4 | Parking |
Operate the wiper switch to check for continuity between wiper motor terminals
No | Description |
1 | Speed |
2 | GND |
3 | B (+) |
4 | Parking |
Attach the positive (+) lead from the battery to terminal 4 and the negative (-) lead to terminal 3.
Remove the rear wiper arm & blade (A) after loosening the rear wiper nut (B).
Remove the rear wiper grommet (A).
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.
Install the rear wiper motor assembly.
Tightening torque Nut :
6.9 ~ 10.8 Nm (0.7 ~ 1.1 kgf.m, 5.0 ~ 8.0 lbf.ft)
Install the tailgate trim.
Install the rear wiper arm and rear wiper cap.
Tightening torque Nut (B) :
3.9 ~ 6.9 Nm (0.4 ~ 0.7 kgf.m, 2.9 ~ 5.1 lbf.ft)
Blade setting end position is matching for ceramic end line.
