6.
Disconnect the connectors relevant to a transaxle.
Remove the air duct.
Remove the battery.
Remove the battery tray.
Remove the air cleaner assemblt.
Rmove the intercooler inlet pipe.
Disconnect the connectors relevant to a transaxle.
Disconnect the ground earth wire.
Remove the bolt(B) which mounts the clutch release cylinder(A) to the inhibiter switch.
Detach the clutch release cylinder(B) clip(A).
Detach the hoses(A), loosening the oil cooler hose clamps.
Using SST(09200-38001), support the engine.
Remove the trasaxle mountinf bracket bolts(A).
Remove the transaxle upper mounting bolts(A).
Remove the bolts which mount the transaxle to the front sub frame.
Lift up the vehicle.
After removing the oil drain plug(A), Drain the fluid.
Support the transaxle with a jack.
Remove the steering column bolt(See 'ST' group).
Remove the driveshafts (See 'DS' group-'DRIVESHAFT').
Remove the bolt(A) which mount the transaxle to the rear sub-frame.
Remove the sub-frame. If it is 4 wheel 1 drive vehile(4WD), remove the propeller shaft first(See 'DS' group-'PROPELLER SHAFT').
Remove the transaxle lower mounting bolts.
Remove the transaxle assembly.
Installation is in the reverse order of removal.
Remove the air duct(A) and hose assembly.
Remove the battery and battery tray.
Remove the air cleaner assembly and air flow sensor.
Remove ther back-up lamp connector and the vehicle speed sensor.
Disconnect the connectors and the terminals.
Remove the clutch release cylinder(A) and lever(B).
Separate the transaxle cable from the transaxle assembly.
Disconnect the steering column shaft from the universal joint in the gear box(See 'ST' group).
Remove the transaxle clutch housing upper mounting bolts.
Remover the transaxle mounting brackets. (front, rear, left(A))
Using SST(09200-38001), support the engine assembly.
Disconnect the power steering oil pressure tube from the pump. Afterwards, stuff the hole with papers.
Remove the wheel and tire.
Disconnect the strut assembly, tie rod and stabilizer bar link from the knuckle.
Remove the wheel speed sensor.
Remove the brake caliper(A) and suspend it with a string.
Lift up the vehicle and remove the undercover(A).
Remove the oil drain plug and drain the fluid.
Remove the front muffler.
Disconnect the steering tube on the cross member(sub-frame). Afterwards, stuff the hole with papers.
Install a jack for the removal of a cross member(sub-frame).
After removing the cross member mounting bolts and nuts, remove the cross member with the steering gear box and the stabilizer bar.
Install a jack for the removal of a transaxle.
Remove the front and the rear roll stopper.
Remove the engine and the transaxle mounting bolts.
Lowering the jack slowly, remove the transaxle.
Installation is in the reverse order of removal.
