3.
Are confirmed trouble on the connector and the terminal?
▶ After repairing the trouble part, check whether DTC occurs or not.
▶ Check the FIS circuit.
The release system for the SRS consists of the SRSCM and FIS.
The above DTC is recorded when a defect is detected in the FIS circuit.
Condition | Probable cause |
- FIS malfunction - SRSCM malfunction | - FIS - SRSCM - Wire harness |
Check all the connectors related to the DTC for contact condition visually.
Check the connector and the terminal.
Check the connector for connection securely.
Check the terminal for contact condition,deterioration,erosion and elasticity.
Do not deform the connector for revising contact.
Are confirmed trouble on the connector and the terminal?
▶ After repairing the trouble part, check whether DTC occurs or not.
▶ Check the FIS circuit.
Preparation
Turn the ignition switch " LOCK ".
Connect the FIS connector.
Connect the SRSCM connector.
Connect the negative (-) terminal cable from the battery, and wait for 30 seconds.
Check
Turn the ignition switch to " ON ", and wait for at least 30 seconds.
Clear the malfunction code stored in the memory with the HI-Scan Pro.
Turn the ignition switch to " LOCK ", and wait for at 30 seconds.
Turn the ignition switch to " ON ", and wait for at 30 seconds.
Using Hi-Scan Pro, check the DTC.
Codes other than these may be output at this time, but they are not relevant to this procedure.
There is no DTC.
▶ From the result of the above inspection, the malfunctioning part can now be considered normal.
▶ Replace the FIS(see page RT- 25).
Preparation
Disconnect the negative(-) terminal cable from the battery,and wait 30 seconds.
Remove the DAB module.
Disconnect the connector of the PAB,SAB,CAB,SIS,FIS and BPT.
Disconnect the SRSCM connector.
Check FIS circuit
Check continuity between the SRSCM connector and the FIS connector as high(+)and high(+), low(-) and low(-).
OK : Continuity
▶ Check the FIS.
▶ Replace the harness between the SRSCM and FIS.
