1.
Detach the wiper cap(A), then remove the rear wiper arm after removing a nut(B).
Tightening torque
Nut(B) : 14~17 Nm (140~170 kgf·cm, 10.1~12.3 lbf·ft)
Detach the wiper cap(A), then remove the rear wiper arm after removing a nut(B).
Tightening torque
Nut(B) : 14~17 Nm (140~170 kgf·cm, 10.1~12.3 lbf·ft)
Remove the handle(B) after removing a nut(A).
Tightening torque
Nut(A) : 10~13 Nm (100~130 kgf·cm, 7.2~9.4 lbf·ft)
Open the tailgate glass then remove the rear wiper motor cover(A).
Disconnect the rear wiper motor connector then remove the rear wiper motor(B) after removing 3 nuts.
Tightening torque
Nut : 14~17 Nm (140~170 kgf·cm, 10.1~12.3 lbf·ft)
Installation is the reverse of removal.
Install the rear wiper arm and blade to the specified position.
Specified position | A |
Distance | 19 ± 5 mm |
※ Specified position : The first deicer line from bottom of the rear window.
Set the rear washer nozzle on the specified spray position.
Remove the 4P connector from the rear wiper motor.
Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively.
Check that the motor operates normally. Replace the motor if it operates abnormally.
