4.
Disconnect the fuel pump connector and check pin connections.
An Engine doesn’t stall quickly by abnormal fuel system. Engine stalling is delayed by remaining fuel pressure. Therefore engine stalls after poor accelerating or hesitating. Engine stalling caused by abnormal fuel system should be checked fuel pressure by inspecting fuel pump and connection of fuel pump power circuit.
IG "OFF"
Disconnect the fuel pump relay
Check pin connections of the relay box and the fuel pump relay.
Disconnect the fuel pump connector and check pin connections.
Are pin connections of fuel pump relay and fuel pump connector normal?
YES
Go to "Fuel pressure Inspection" procedure as below.
NO
Repair(Replace) pin connections of the fuel pump relay and fuel pump connector.
■ Method of checking fuel pump power circuit.
1. IG "ON"
2. Connect "30" terminal and "87" terminal with jump wire after disconnecting the fuel pump relay.
3. Measure voltage of the fuel pump connector after disconnecting the fuel pump connector.
※ If voltage is measured as above fig2 after providing power directly, power circuit of the fuel pump is normal.
IG "OFF"
Install a fuel pressure gauge between the delivery pipe and the fuel feed hose.
Check the fuel pressure accelerating engine after engine "ON"
Fuel pressure specification : 360 kpa (3.6kg/cm², 51.2psi)(when vehicle is accelerated ).
Is fuel pressure within specification when vehicle is accelerated?
YES
Fuel pump is OK.
NO
Replace the fuel pump assembly.
■ Performance test of the fuel pump by ampere meter
1. Install ampere meter to power supply harness of the fuel pump after starting engine.
2. Measure ampere of power supply harness accelerating engine.
Ampere specification : 4.8~5.0 A
