2.
Inspect the connector on wire harness side as shown.
Disconnect the wire connector to DRL module(A) from the right side strut housing.
Inspect the connector on wire harness side as shown.
Tester connection | Condition | Specified condition |
1-Ground | Constant | Continuity |
5-Ground | Head lamp switch OFF | No continuity |
Head lamp switch ON | Continuity | |
6-Ground | Constant | Continuity |
7-Ground | Constant | Battery voltage |
9-Ground | Ignition switch ON or START | Battery voltage |
Ignition switch ACC or LOCK | No voltage | |
11-Ground | Constant | Battery voltage |
3-Ground | Engine Stop | No voltage |
Engine Running | Battery voltage |
If circuit is not as specified, refer to schematic diagram and inspect short or circuits.
