COMPONENT LOCATION

Refer to DTC P0712

GENERAL DESCRIPTION

Refer to DTC P0712

DTC DESCRIPTION

When the signal voltage from an oil temperature after 10 minute engine running is higher than 4.57V for 1 second or this code is memorized after ignition key on, this code will set.

DTC DETECTING CONDITION

Item

Detecting Condition & Fail Safe

Possible cause

DTC Strategy

● Voltage monitering

● Oil temperature sensor circuit

● Oil temperature sensor component

Enable Conditions

● 10 minute engine running

● when the code is memorized after ignition key on

Threshold value

● Output signal ≥ 4.57V

Diagnostic Time

● for 1 second

Fail Safe

● No learning, No INTELLIGENT-SHIFT until IG KEY OFF and set the oil termperature 80°C.

SCHEMATIC DIAGRAM

Refer to DTC P0712

TERMINAL & CONNECTOR INSPECTION
1.

Many malfunctions in the electrical system may be caused from poor harness and terminals. These faults can be caused by interference from other electrical systems and mechanical or chemical damage.

2.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

▶ Repair as necessary and go to "Verification vehicle Repair" procedure.

▶ Go to the next procedure.

POWER SUPPLY CIRCUIT INSPECTION

Refer to DTC P0712

SIGNAL CIRCUIT INSPECTION

Refer to DTC P0712

COMPONENT INSPECTION

Refer to DTC P0712

SPECIFICATION

Refer to DTC P0712

Яндекс.Метрика