Description

The purpose of the Inspection is to analyze if the cause of poor power/acceleration is due to fuel system or ignition system or intake/exhaust system. To analyze the cause of poor power/acceleration, Using the tendency of HO2 sensor waveform with stall test of the "D" range.

Diagnostic Procedure
1.

Engine "ON" and warm up the engine until cooling fan is operated.

2.

Connect Scanner to Data Link Connector (DLC).

3.

Analyze the cause of engine hesitation by stall test of the "D" range.

A.

Specification : refer to current data as below.

caution

This current data is nothing but an example at certain condition. Thus, the real current data and waveform can be different from this example.

B.

When current data measured similar to [Fig1],

Go to "Fuel system Inspection" procedure.

C.

When current data measured similar to [Fig2],

Go to "Intake/exhaust system Inspection" procedure.

D.

When current data is similar to [Fig.3],

Go to "Ignition system Inspection" procedure

Яндекс.Метрика