3.
Measure resistance between terminals 4 of the sensor harness connector and chassis ground.
Specification : Approx. 0Ω
Ignition "OFF".
Disconnect IATS connector.
Measure resistance between terminals 4 of the sensor harness connector and chassis ground.
Specification : Approx. 0Ω
Is resistance within the specification?
 | ▶ Go to next step as below. |
 | ▶ Repair open circuit and go to "Verification of Vehicle Repair" procedure. |
Ignition "ON" & Engine "OFF"
Measure voltage between terminals 3 of the sensor harness connector and chassis ground.
Specification : Approx. 5V
Is voltage within the specification?
| ▶ Go to next step as below |
| ▶ Check for open or short to battery in signal harness. Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage.
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Has a problem been found?
| ▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure. |
| ▶ Go to next step as below |
