Ignition "ON" & Engine "OFF".
Connect scan tool and select "Diagnostic Trouble Codes(DTCs)" mode.
Using a scantool, Clear DTC.
Using a "SCAN TOOL", Operate "LEARNING " Reset,
Perform the "LEARNING"
IG OFF ↔ IG ON (Repeat 2~3times),and then Monitor the "DTC"
Is DTC Re-displayed ?
YES
Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace PCM/TCM as necessary and then Go to "Verification of Vehicle Repair" procedure.
NO
Fault is intermittent caused by poor contact in the sensor’s and/or TCM(PCM)’s connector or was repaired and TCM(PCM) memory was not cleared.And Go to Component Inspection procedure.
METHOD OF LEARNING RESET
※ IT IS NECESSARY TO LEARNING RESET, AFTER REPLACED TRANSMISSION
ERASING CONDITION
1) SELECT LEVER POSITION IS "P" OR "N"
2) VEHICLE SPEED 〓 Okm/h
3) IGNITION "ON" , ENGINE "OFF"
USING A SCAN TOOL, OPERATE "LEARNING" RESET
IG "ON" ↔ IG "OFF"(2~3 TIMES),AFTER RESET
