Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by in terference from other electrical systems, and mechanical or chemical damage.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

Has a problem been found?

YES

▶ Repair as necessary and go to "Verification of Vehicle Repair" procedure.

NO

▶ Go to "Signal Circuit Inspection" procedure.

Ignition "OFF".

Disconnect HO2S connector.

Ignition "ON" & Engine "OFF".

Measure voltage between terminal 1 of the sensor harness connector and chassis ground.

Specification : Approx. 0V

Is voltage within the specification?

YES

▶ Go to "Component Inspection" procedure.

NO

▶ Repair open in the signal circuit and go to "Verification of Vehicle Repair" procedure.