3.
Measure resistance between terminals 1 and 2 of OTS connector.(Component side)
Specification
Temp.(°C) | Temp.(°F) | Resistance(kΩ) | Temp.(°C) | Temp.(°F) | Resistance(kΩ) |
-20 | -4 | 16.52 | 40 | 104 | 1.11 |
0 | 32 | 6.00 | 60 | 140 | 0.54 |
20 | 68 | 2.45 | 80 | 176 | 0.29 |
Ignition "OFF"
Disconnect OTS connector.
Measure resistance between terminals 1 and 2 of OTS connector.(Component side)
Specification
Temp.(°C) | Temp.(°F) | Resistance(kΩ) | Temp.(°C) | Temp.(°F) | Resistance(kΩ) |
-20 | -4 | 16.52 | 40 | 104 | 1.11 |
0 | 32 | 6.00 | 60 | 140 | 0.54 |
20 | 68 | 2.45 | 80 | 176 | 0.29 |
Is sensor switching properly?
YES
▶ Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
NO
▶ Check OTS for contamination, deterioration, or damage. Substitute with a known-good OTS and check for proper operation. If the problem is corrected, replace OTS and then go to "Verification of Vehicle Repair" procedure.
