3.
Measure resistance between terminals 1 and 2 of the injector connector(Component side).
Specification : Approx. 13~16Ω at 20℃(68℉)
Ignition "OFF".
Disconnect injector connector
Measure resistance between terminals 1 and 2 of the injector connector(Component side).
Specification : Approx. 13~16Ω at 20℃(68℉)
Is resistance within the specification?
YES
▶ Check for intermittent fault. Observe the data parameter for a sudden change while wiggling the wiring and tapping lightly on the suspect component.
Be careful not to damage wires or components during the test.
Repair as necessary and go to next step as below.
NO
▶ Check Injector for contamination, deterioration, or damage. Substitute with a known-good Injector and check for proper operation. If the problem is corrected, replace Injector and then go to "Verification of Vehicle Repair" procedure
