Component Location
General Description

Because both A/T and M/T fuel control map is inputted in one type of ECM and selecting option is possible, one type is applied to both A/T and M/T option.

When ECM is installed to vehicle, A/T and M/T recognition is performed by ECM automatically as checking whether ground line(ECM connector C213-2 terminal 81) is grounded or opened.(A/T and M/T recognition is performed every IG KEY ON process.)

If A/T, M/T recognition is not fulfilled well or any error occurs during the process, engine power generation is not sufficient and glow lamp on cluster blinks.

A/T : ECM connector C213-2 terminal 81 is grounded

M/T : ECM connector C213-2 terminal 81 is opened(no wiring exists)

DTC Description

P1588 is set when the signal from A/T, M/T auto recognition terminal(ECM C213-2 terminal 81) changes during engine running. This code is due to open in terminal for A/T option, grounded condition for M/T option. This code is normally arises from A/T option vehicle. Check the grounding condition of A/T, M/T auto recognition terminal.

DTC Detecting Condition

Item

Detecting Condition

Possible Cause

DTC Strategy

● Voltage monitoring

● A/T, M/T recognition terminal circuit

● ECM component failure

Enable Conditions

● Engine running

Threshold Value

● A/T, M/T auto recognition signal changes at engine ON.

Diagnostic Time

● 0.6 sec.

Fail Safe

Fuel Cut

NO

● Glow Lamp blinks.

EGR Off

NO

Fuel Limit

NO

Check Lamp

NO

Schematic Diagram
note
To view Flash content, you need to install the appropriate browser extension
Яндекс.Метрика