Monitor DTC Status
1.

Connect scantool to Data Link Connector(DLC).

2.

Warm up the engine to normal operating temperature.

3.

Monitor DTC(Diagnostics Trouble Code) on the scantool.

4.

Is the same DTC displayed again?

▶ Check part number and tire size.

▶ Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Fault is intermittent caused by poor contact in the sensor’s and/or 4WD ECM(TCCU) connector or was repaired and 4WD ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure

Яндекс.Метрика