4.
Monitor the "TORQUE CONVERTER(DAMPER) CLUTCH" parameter on the scantool
a.
Specification : TCC SLIP>5RPM
Connect scantool to data link connector(DLC)
Engine "ON".
Sellect "D RANGE" and drive vehicle
Monitor the "TORQUE CONVERTER(DAMPER) CLUTCH" parameter on the scantool
Specification : TCC SLIP>5RPM
Are "TCC SOLENOID DUTY and TCC SLIP" within specifications ?
YES
Fault is intermittent caused by poor contact in the sensor’s and/or TCM(PCM)’s connector or was repaired and TCM(PCM) memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure
NO
Go to "Component Inspection" procedure
