4.
Measure the resistance between terminals 1 and 3 of the primary ignition coil.(Component side)
Specification : Approx. 0.96 ± 10% (Ω) at 20℃(68℉)
Ignition "OFF".
Disconnect ignition coil connector.
Visually/physically inspect the following items:
Damage, cracks and flashover.
Measure the resistance between terminals 1 and 3 of the primary ignition coil.(Component side)
Specification : Approx. 0.96 ± 10% (Ω) at 20℃(68℉)
Measure the secondary coil resistance.
Measure the resistance between the high-voltage terminal referring to following diagram.
Be sure, when measuring the resistance of the secondary coil, to disconnect the connector of the ignition coil.
Specification : Approx. 13.3 ± 1.9 (kΩ) at 20℃(68℉)
Is resistance within the specification?
YES
▶ Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "Verification of Vehicle Repair" procedure.
NO
▶ Check ignition coil for contamination, deterioration, or damage. Substitute with a known-good ignition coil and check for proper operation. If the problem is corrected, replace ignition coil and then go to "Verification of Vehicle Repair" procedure.
