4.
Install the fixing clip (A).
[Abnormal wire tension: No free stroke]
[Normal wire tension: Free stroke]
Turn on the ignition key, but don't start the engine.
Remove the fixing clip (A) after holding for 15 seconds under IG ON condition.
Adjust the position of the accelerator cable grommet (B) to secure free stroke.
Pull the grommet (B) by taking the cable cap (C) in the direction of an arrow ① until the cable wire tighten.
Push the grommet (B) by taking the cable cap (C) in the direction of an arrow ② as below free stroke specification.
Free stroke specification: 1 ~ 3 mm (0.0393 ~ 0.1181 in.)
Install the fixing clip (A).
[Abnormal wire tension: No free stroke]
[Normal wire tension: Free stroke]
Check the normal operation of the accelerator pedal.
