1.
Disconnect the injector connector (A).
Common Rail Fuel Injection System is subject to extremely high pressure (Approximately 1,600 bar)
Never perform any work on injection system with engine running or within 30 seconds after the engine stops.
Always pay attention to safety precaution.
Ensure the absolute cleanliness.
It is not recommended to remove the injectors without any notice.
Disconnect the injector connector (A).
After removing the clip (B), disconnect the retun hose (C) from the injectors
Disconnect the high pressure pipe (A) connecting the injectors with the common rail.
Rotate the lever (A) clockwise and pull it upward.
Unscrew the clamp tightening bolt (A) and pull the injector upward with the "Injector Remover" and the "Injector Remover Adapter" (Refer to "SPECIAL SERVICE TOOL" section).
