10301316

1.

To Remove the transaxle assembly.(See 'TR' group - 'Manual Transzxle')

2.

If the clutch cover is attached to the flywheel, remove the release bearing using snap-ring pliers.

(1)

Rotate the release bearing in an easy direction in order to examine the snap ring.

(2)

Insert the pliers under the wave washer as shown in the illustration and place it in the center of the snap ring.

(3)

Spread the snap ring by pushing down on the bearing as shown in the illustration.

(4)

The snap ring (A) at expanded state is shown in the figure.

(5)

In the snap ring expanded, pull out the release bearing and remove it.

3.

Insert the special tool (09411-11000) in the clutch disc to prevent the disc from shifting.

4.

Loosen the bolts which attach the clutch cover to the flywheel in a star pattern. Loosen the bolts in succession, one or two turns at a time, to avoid bending the cover.

note

Do not clean the clutch disc or the release bearing with cleaning solvent.

5.

Remove the release fork shaft and bushing.

6.

Apply multipurpose grease to the spline of the disc.

Grease: CASMOLY L 9508 0.2gr

caution

When installing the clutch, apply grease to each part, but be careful not to apply excessive grease.

It can cause clutch slippage and judder.

7.

Install the clutch disc assembly to the flywheel using the special tool (09411-11000).

8.

Install the clutch cover assembly to the flywheel and temporarily tighten the bolts one or two steps at a time in a star pattern.

Tightening torque

Clutch cover bolt:

15 ~ 22 Nm (150~220 kgf·cm, 11~16 lbf·ft)

9.

Align the bearing (A) to the release fork (B) and then install it to the sleeve of the housing.

caution

Apply multipurpose grease (CASMOLY L9508) to the bearing sleeve and contact point of the release fork.

10.

Install the release lever to the release fork.

11.

Install the transaxle assembly to the engine.

caution

If the transaxle assembly is installed to the engine without performing this step, the release bearing can be separated, as the release fork rotates freely.

12.

After finishing step 6, push the release lever to the arrow mark. If there is a click sound, the release bearing and clutch cover are aligned correctly. If the assembly does not snap into place, start with step 1 again.

Release lever operating range is 3° or less. If the range is over 3°, the release bearing and clutch cover are not aligned correctly. Push the release lever to the arrow mark one more time.