Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the DOJ. boot bands and pull the DOJ. boot from the DOJ. outer race.
Using a plier or flat-tipped (-) screwdriver, remove the LH boot band and LH DOJ. boot band from the driveshaft.
Remove RH boot band and RH DOJ. boot band.
Be careful not to damage the boot.
Remove the circlip(B) with a flat-tipped (-) screwdriver (A).
Pull out the driveshaft from the DOJ. outer race.
Remove the snap ring(A) and take out the inner race(B), cage(C) and balls(D) as an assembly.
Clean the inner race, cage and balls without disassembling.
Remove the BJ. boot bands and pull out the DOJ. boot and BJ. boot.
If the boot(A) is to be reused, wrap tape(B) around the driveshaft splines(C) to protect the boot(A).
Do not disassemble the BJ. assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the circlip(B) from driveshaft splines(A) of the transaxle side TJ. case.
Remove the both boot clamps from the transaxle side TJ. case.
Using a plier or flat-tipped (-) screwdriver, remove the both clamps(TJ. boot band(B), boot band(A)) of the transaxle side.
Pull out the boot from the transaxle side joint(TJ).
While dividing joint(TJ) boot(A) of the transaxle side, wipe the grease in TJ. case(B) and collect them respectively.
Be careful not to damage the boot.
According to below the illustrated, put marks(D) on roller of trunion assembly(A), TJ. case(B) and spline part(C), for providing assembly.
Using a plier or flat-tipped (-)screwdriver, remove the circlip(A).
Remove the trunion assembly(B) from the driveshaft(A) using the special tool(09495-33000).
Clean the trunion assembly.
Remove the boot(A) of the transaxle side joint(TJ).
For reusing the boot(A), wrap tape(B) around the driveshaft splines(C) to protect the boot(A).
Using a plier or flat-tipped (-) screwdriver, remove the both side of clamp(B) of the dynamic damper(A).
Fix the driveshaft(A) with a vice(B) as illustrated.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
Saperate the dynamic damper(A) from the shaft(B) carefully.
Using a plier or flat-tipped (-) screwdriver, remove the clamp on the side of wheel.
Pull out the joint(BJ) on the side of wheel into the transaxle direction.
Be carefull not to damage the boot.
