3.
To install the dynamic damper, keep the BJ. and driveshaft in a straight line and secure the dynamic damper with the dynamic damper band.
Wrap tape around the driveshaft splines (DOJ. side ) to prevent damage to the boots.
Apply grease to the driveshaft and install the boots. (See page DS - 4)
To install the dynamic damper, keep the BJ. and driveshaft in a straight line and secure the dynamic damper with the dynamic damper band.
Apply the specified grease to the inner race(A) and cage(B). Install the cage(B) so that it is offset on the race as shown.
Use the grease included in the repair kit.
Apply the specified grease to the cage and fit the balls into the cage.
Position the chamfered side(A) as shown in the illustration. Install the inner race on the driveshaft(B), and then the snap ring.
Apply the specified grease to the outer race and install the BJ. outer race onto the driveshaft. (See page DS - 4)
Apply the specified grease into the DOJ. boot and install the boot with a clip. (See page DS - 4)
Tighten the DOJ. boot bands.
Add the specified grease to the BJ. as much as wiped away at inspection.
Install the boots.
Tighten the BJ. boot bands.
To control the air in the DOJ. boot, keep the specified distance between the boot bands when they are tightened.
Wrap tape around the driveshaft splines (TJ. side) to prevent damage to the boots.
Apply grease to the driveshaft and install the boots. (See page DS - 4)
Install the clamps to both boots.
To reassemble the dynamic damper(A), keeping the shaft(B) in the straight, tighten the dynamic damper(A) with dynamic band(C), as the illustration.
Install the TJ. boot bands and TJ. boot.
Install the trunion assembly(A) and the circlip(E) to the spline(C) on the drivershaft.
At this time align the marks(D) each other.
Add the specified grease to the TJ. as mush as wiped away at inspection.
Install the boots.
Tighten the TJ. boot bands.
To control the air in the T.J. boot, keep the specified distance between the boot bands when they are tightened.
