1.
Apply gear oil on the driveshaft oil seal case contacting surface(B) and transaxle case splines(A).
[2WD]
[4WD]
Apply gear oil on the driveshaft oil seal case contacting surface(B) and transaxle case splines(A).
Before installing the driveshaft(C), set the opening side of the circlip(D) facing downward.
After installation, check that the driveshaft cannot be removed by hand.
Install the BJ. Into the knuckle.
Install the lower arm mounting bolts(A).
Tightening torque
100 ~ 120Nm (1000 ~ 1200Kgf.cm, 73.8 ~ 88.5lbf.ft)
After installing the washer(B) with convex surface outward, install the castle nut(A) and the split pin(C).
Tightening torque
200 ~ 280Nm (2000 ~ 2800Kgf.cm, 147.5 ~ 206.6lbf.ft)
Install the front wheel and tire(A) on the front hub(B).
Tightening torque
90 ~ 110Nm (900 ~ 1100Kgf.cm, 66.4 ~ 81.2lbf.ft)
Be careful not to damage the hub bolts(C) then install the front wheel and tire(A).
