2.
Remove the rear wheel and tire(A) from rear hub(B).
caution
Be careful not to damage the hub bolts(C) then remove the rear wheel and tire(A).
Loosen the wheel nuts slightly.
Raise the rear of the vehicle, and make sure it is securely supported.
Remove the rear wheel and tire(A) from rear hub(B).
Be careful not to damage the hub bolts(C) then remove the rear wheel and tire(A).
Remove the wheel speed sensor(B) from the axle carrier(A).
Remove the split pin(A), then remove castle nut(B) and washer(C) from the rear hub under applying the break.
Remove the caliper mounting bolts(A), and hang the caliper assembly(B) to one side. To prevent damage to the caliper assembly or brake hose, use a short piece of wire to hang the caliper from the undercarriage.
Remove the rear axle assembly(A).
Remove the trailing arm mounting bolt(B).
Remove the suspension arm mounting nuts(C).
Remove the strut mounting nuts(D).
Install the rear axle assembly(A).
Install the strut mounting nuts(D).
Tightening torque
140 ~ 160Nm (1400 ~ 1600Kgf.cm, 103.3 ~ 118lbf.ft)
Install the suspension arm mounting nuts(C).
Tightening torque
140 ~ 160Nm (1400 ~ 1600Kgf.cm, 103.3 ~ 118lbf.ft)
Install the trailing arm mounting bolt(B).
Tightening torque
100 ~ 120Nm (1000 ~ 1200Kgf.cm, 73.8 ~ 88.5lbf.ft)
Install the brake caliper(B), then tighten the mounting bolt(A).
Tightening torque
50 ~ 60Nm (500 ~ 600Kgf.cm, 36.9 ~ 44.3lbf.ft)
Install the washer(C), castle nut(B) and split pin(A) from the rear hub.
Tightening torque
200 ~ 280Nm (2000 ~ 2800Kgf.cm, 147.5 ~ 206.6lbf.ft)
Install the wheel speed sensor(B) from the axle carrier(A).
Install the rear wheel and tire(A) on the rear hub(B).
Tightening torque
90 ~ 110Nm (900 ~ 1100Kgf.cm, 66.4 ~ 81.2lbf.ft)
Be careful not to damage the hub bolts(C) then install the rear wheel and tire(A).
Check the hub bearing for wear or damage.
Check the carrier for cracks.
