2.
Remove the circlip(B) with a flat-tipped (-)screwdriver(A).
Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.
Remove the DOJ. boot bands and pull the DOJ. boot from the DOJ. outer race.
Using a plier or flat-tipped (-) screwdriver, remove the LH boot band and LH DOJ. boot band from the driveshaft
Remove RH boot band and RH DOJ. boot band in the same way of LH removal procedure.
Be careful not to damage the boot.
Remove the circlip(B) with a flat-tipped (-)screwdriver(A).
Pull out the driveshaft from the DOJ. outer race.
Remove the snap ring(A) and take out the inner race(B), cage(C) and balls(D) as an assembly.
Clean the inner race, cage and balls without disassembling.
Remove the BJ. boot bands and pull out the DOJ. boot and BJ. boot.
If the boot(A) is to be reused, wrap tape(B) around the driveshaft splines(C) to protect the boot(A).
