1.
Apply gear oil on the driveshaft differential case(B) contacting surface(B) and driveshaft(A) splines.
Apply gear oil on the driveshaft differential case(B) contacting surface(B) and driveshaft(A) splines.
Before installing the driveshaft(A), set the opening side of the circlip facing downward.
After installation, check that the driveshaft(A) cannot be removed by hand.
Install the BJ. Into the knuckle.
Install the suspension arm mounting nuts(C) and trailing arm mounting bolt(B) from the knuckle(B).
Tightening torque
Suspension arm mounting nuts(C)
140 ~ 160Nm (1400 ~ 1600Kgf.cm, 103.8 ~ 118lbf.ft)
Trailing arm mounting bolt(B)
100 ~ 120Nm (1000 ~ 1200Kgf.cm, 73.8 ~ 88.5lbf.ft)
Install the washer(C), castle nut(B) and split pin(A) from the rear hub.
Tightening torque
200 ~ 280Nm (2000 ~ 2800Kgf.cm, 147.5 ~ 206.6lbf.ft)
Install the wheel speed sensor(B) from the knuckle(A).
Install the rear wheel and tire(A) on the rear hub(B).
Tightening torque
90 ~ 110Nm (900 ~ 1100Kgf.cm, 66.4 ~ 81.2lbf.ft)
Be careful not to damage the hub bolts(C) then install the rear wheel and tire(A).
