5.
Select "ENGINE CONTROL".
This procedures is to forcibly regenerate the CPF with scan tool when the CPF doesn't have been regenerated during driving. For example, if the vehicle has repeated "Low speed driving" or "Short distance driving", the CPF regeneration procedure cannot be proceeded because "Regeneration Mode" doesn't made.
If performing the CPF service regeneration mode indoors, fire or burn injuries may occur by high-temperature exhaust gas.
Therefore the CPF service regeneration mode must be performed in a outdoor safe zone.
Engine coolant temperature: about 70℃
Engine at idle
P-range (A/T) or Neutral (M/T)
Normal battery voltage
Electrical fully load (A/C ON if equipped, Blower ON with maximum speed, Head Lamp ON, Wiper ON, Other Lamps ON, etc.)
Turn ignition switch OFF.
Connect a scan tool to Data Link Connector (DLC).
Start engine at idle and P-range (A/T) or neutral (M/T).
Apply electrical fully load to the vehicle (A/C ON, Blower ON with maximum speed, Head Lamp ON, Wiper ON, and Other Lamps ON, etc.)
Select "ENGINE CONTROL".
Select "MANUAL SELECTION MODE".
Select "D 2.0L VGT DIESEL".
Select "CPF SERVICE REGENERATION".
Press "ENTER" key after looking around data memorized in ECM.
Press "STRT" key.
