1.
Disconnect the cover fixing clip(A) on the universial joint indoor driver isde, loosen the noise covers(B).
Disconnect the cover fixing clip(A) on the universial joint indoor driver isde, loosen the noise covers(B).
Loosen the iniversial joint and the gear box mounting bolt and disconnect the universial joint from the gear box.
Keep the neutral-range to prevent the damage of the clock spring inner cable when you handlethe steering wheel.
Lift up the vehicle.
Remove the front tires (RH/LH).
After removing the split pin, disconnect the tie rod(A) from the knuckle(B) by using the special tool (09568-34000).
Drain the power steering fluid. (see page ST-11)
Remove the engine under cover(A).
Remove the front muffler assembly(A).
Disconnect the end tube of the pressure hose(A) and the end hose of the return hose(B) from the gear box.
Remove the bracket(A) holding the end tubes of the pressure tube and the return tube.
Remove the mounting clamp of power steering gear box, and also remove the clamp holding the pressure tube and the return tube.
Remove the mounting bolt(A) from the power steering gear box.
Pull the power steering gear box assembly(A) toward the right side of the vehicle.
When removing the gear box, pull it out carefully and slowly so as not to cause damage to the Bellows(B).
