1.
Remove the tie rod end(A) from the tie rod(B).
Remove the tie rod end(A) from the tie rod(B).
After mounting the tie rod end(A) in a vise, remove the dust cover(B) from the ball joint.
Remove the bellows band(A).
Remove the bellows clip(A).
Pull the bellows out toward the tie rod.
Check for rust on the rack when the bellows are replaced.
Remove the feed tube from the rack housing.
While moving the rack slowly, drain the fluid from the rack housing.
Unstake the tab washer(A) which fixes the tie rod(B) and rack(C) with a chisel.
Remove the tie rod(A) from the rack(B).
Remove the tie rod(A) from the rack(B), taking care not to twist the rack.
Remove the yoke plug locking nut(A), and then remove the yoke plug.
Remove the lock nut(A), yoke plug(B), rack support spring(C), rack support yoke(D) and bushing(E) from the gear box.
Remove the valve body housing(A) by loosening the two bolts(B).
Remove the rack bushing and the rack from the rack housing.
Remove the O-ring(A) from the rack bushing(B).
Remove the oil seal(A) from the rack bushing(B).
Remove the pinion vlave assembly(A) from the valve body housing(B) with a soft hammer(C).
Using the special tool, remove the oil seal and ball bearing from the valve body housing.
Remove the oil seal and O-ring from the rack housing.
Be careful not to damage the pinion valve cylinder inside of the rack housing.
Using the special tool(06573-21200, 09555-21000), remove the oil seal(A) from the rack housing.
Be careful not to damage the rack cylinder inside of the rack housing.
