1.
Remove the trailing arm mounting bolt(A) and suspension arm mounting bolt(B).
[2WD]
Remove the trailing arm mounting bolt(A) and suspension arm mounting bolt(B).
Remove the opposite side trailing arm mounting bolt and suspension arm mounting bolt.
After supporting the rear cross member assembly(B) with the jack(A), remove the cross member mounting bolts and nuts(C).
Remove the suspension arm bracket mounting bolts(A).
Remove the suspension arm(B).
Install the suspension arm bracket mounting bolts(A).
Tightening torque
160~180 Nm (1600~1800 Kgf·cm, 118.0~132.8 Ibf·ft)
Make sure that the arrow mark(B) on the rear cross member(A) should place the front face of the vehicle.
Rear suspension arm(C)-to-rear carrier bolts should be temporarily tightened, and then fully tightened with the vehicle on the ground in unloaded condition.
Tightening torque
160~180 Nm (1600~1800 Kgf·cm, 118.0~132.8 Ibf·ft)
Remove the muffler(A).
Remove the suspension arm mounting bolts(A).
Remove the opposite side suspension mounting bolts.
Remove the coupling control connector(A).
After supporting the rear cross member assembly(B) with a jack(A), remove the cross member mounting bolts and nuts(C).
Remove the propeller shaft. (see page DS-propeller shaft)
Remove the rear differential(A) from the cross member(B).
Remove the suspension arm bracket mounting bolts(A).
Remove the suspension arm(B).
Install the suspension arm bracket mounting bolts(A).
Tightening torque
140~160 Nm (1400~1600 Kgf·cm, 103.3~118.0 Ibf·ft)
Install the rear differential(A) on the cross member(B).
Tightening torque
90~120 Nm (900~1200 Kgf·cm, 59.0~88.5 Ibf·ft)
Install the propeller shaft. (see page DS-propeller shaft)
After supporting the rear cross member assembly(B) with the jack(A), install the cross member mounting bolts and nuts(C).
Tightening torque
100~120 Nm (1000~1200 Kgf·cm, 73.8~88.5 Ibf·ft)
Install the coupling control connector(A).
Rear suspension arm-to-rear carrier bolts(A) should be temporarily tightened, and then fully tightened with the vehicle on the ground in unloaded condition.
Tightening torque
140~160 Nm (1400~1600 Kgf·cm, 103.3~118.0 Ibf·ft)
