Remove the air duct(A) and hose assembly.

Remove the battery and battery tray.

Remove the air cleaner assembly and air flow sensor.

Remove ther back-up lamp connector and the vehicle speed sensor.

Disconnect the connectors and the terminals.

Remove the clutch release cylinder(A) and lever(B).

Separate the transaxle cable from the transaxle assembly.

Disconnect the steering column shaft from the universal joint in the gear box(See 'ST' group).

Remove the transaxle clutch housing upper mounting bolts.

Remover the transaxle mounting brackets. (front, rear, left(A))

Using SST(09200-38001), support the engine assembly.

Disconnect the power steering oil pressure tube from the pump. Afterwards, stuff the hole with papers.

Remove the wheel and tire.

Disconnect the strut assembly, tie rod and stabilizer bar link from the knuckle.

Remove the wheel speed sensor.

Remove the brake caliper(A) and suspend it with a string.

Lift up the vehicle and remove the undercover(A).

Remove the oil drain plug and drain the fluid.

Remove the front muffler.

Disconnect the steering tube on the cross member(sub-frame). Afterwards, stuff the hole with papers.

Install a jack for the removal of a cross member(sub-frame).

After removing the cross member mounting bolts and nuts, remove the cross member with the steering gear box and the stabilizer bar.

Install a jack for the removal of a transaxle.

Remove the front and the rear roll stopper.

Remove the engine and the transaxle mounting bolts.

Lowering the jack slowly, remove the transaxle.