1.
Raising the jack slowly, tighten the transaxle lower mounting bolts(A).
Raising the jack slowly, tighten the transaxle lower mounting bolts(A).
Install the LH driveshaft(A) (Refer to 'DS'-group) and the silencer.
Lifting the cross member up with the jack and the SST(09624-38000) slowly, tighten the mounting bolts.
TORQUE
Front mounting(A) :
137.3~156.9Nm (1400~1600kgf.cm, 101.3~115.7lb-ft)
Fix the front/rear roll stopper(A) to brackets with the mounting bolts.
TORQUE :
49.0~63.7Nm (500~650kgf.cm, 36.2~47.0lb-ft)
Install the transfer assembly.
Insert the RH driveshaft into the transfer case. (See 'DS' group)
Install the front exhaust pipe. (See 'EM' group)
Inserting the power steering return hose(A), fix it with a clamp(B).
Tightening the steering bar tie rod mounting nut, insert a new split pin. (Refer to 'ST'-group)
TORQUE :
23.5~33.3Nm (240~340kgf.cm, 17.4~24.6lb-ft)
Tighten the stabilizer bar link mounting bolt. (Refer to 'SS'-group)
TORQUE :
98.1~117.7Nm (1000~1200kgf.cm, 72.3~86.8lb-ft)
Tighten the lower arm ball joint and folk mounting bolt. (Refer to 'SS'-group)
TORQUE :
98.1~117.7Nm (1000~1200kgf.cm, 72.3~86.8lb-ft)
After tightening the transaxle drain plug and filling the manual transaxle fluid, tighten the oil filler plug.
TORQUE :
29.4~34.3Nm (300~350kgf.cm, 21.7~25.3lb-ft)
Maunual transaxle fluid: SAE 75W/85
Tighten the steering joint assembly bolt. (Refer to 'ST'-group)
TORQUE :
17.7~24.5Nm (180~250kgf.cm, 13.0~18.1lb-ft)
Install the front wheel＆tires. (See 'SS' group)
Install the transaxle insulator mounting bracket(A).
Install the battery tray(A) mounting bracket.
Remove the SST(09200-38001).
Tighten the transaxle upper mounting bolts.
Tightening the power steering pressure hose(A) bolt(B), refill the power steering fluid.
TORQUE:
63.7~73.5Nm (650~750kgf.cm, 47.0~54.2lb-ft)
Connect the C.S.C tube(C) and install the clip (B) and loosen the clamping(A).
Install the shift cable assembly (A) with the clips(B) and pins(C).
Install the intake hose and the vehicle speed sensor connector.
After connecting the front lamp connecter (B) install the terminals, the grounds(A), and the fuse＆relay box.
Install the intercooler tube(A) and air duct(B).
Install the battery tray and air cleaner.
Install the air duct cover and air flow sensor.
Install the battery.
Install the air duct(A).
