2.
After disconnecting the glass run (A) and weatherstrip (B), then remove the delta molding (C).
Put in gloves to protect your hands.
Remove the door trim (See page BD- 37).
After disconnecting the glass run (A) and weatherstrip (B), then remove the delta molding (C).
Carefully move the glass (A) until you can see the bolts, then loosen them.Carefully pull the glass out through the window slot (B).
Take care not to drop the glass and scratch the glass surface.
Installation is the reverse of removal.
Roll the glass up and down to see if it moves freely without binding.
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
Adjust the position of the glass as necessary (See page BD- 43).
Remove the rear door trim (See page BD- 37).
Remove the glass (See page BD- 38).
After removing the rear channel mounting bolt and nut, remove the rear channel (A).
Installation is the reverse of removal.
Remove the rear door trim (See page BD- 37).
Disconnect the power window motor connector (A).
After loosening the mounting nut, remove the power window motor (B).
Installation is the reverse of removal.
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
Adjust the position of the glass as necessary (See page BD- 43).
Remove the door trim (See page BD- 37).
Remove the glass (See page BD- 38).
Remove the rear channel (See page BD- 39).
Disconnect the power window motor connector (A), speaker connector (B) and actulator connector (C). Detach the harness clip.
Remove the door module assembly (A).
Installation is the reverse of removal.
Make sure the door locks and opens properly.
Put on gloves to protect your hands.
Remove the door trim (See page BD- 37).
Remove the glass (see page BD- 38).
Remove the rear door module (see page BD- 40).
Remove the outside handle base (A).
Remove the outside hand lever (A) and cover (B).
Installation is the reverse of removal.
Make sure the door locks and opens properly.
Remove the rear door module (See page BD- 40).
Remove the latch cover, then disconnect the lock cable (A) and inside handle cable (B).
Remove the rear door latch (C).
Installation is the reverse or removal.
Remove the rear door trim (See page BD- 37).
After disconnecting the speaker connector (A), remove the speaker (B).
Installation is the reverse of removal.
Remove the front door trim (See page BD- 37).
Loosen the inside handle (A) mounting screw.
Push the inside handle forward to disconnect from the door module.
Disconnect the lock cable (A) and inside handle cannect cable (B).
Installation is the reverse of removal.
Make sure the door locks and opens properly.
Remove the front door trim (See page BD- 37).
Release the hooks (A), and then remove the door belt weatherstrip (B).
Installation is the reverse of removal.
