Remove the shift cable mounting nut(A).

Remove the inhibiter switch loosening the mounting bolts.

Refering to 'INSPECTION', check for continuity. If there is an error, replace the inhibiter switch.

After tightening the shift cable mounting nut, connect the inhibiter switch.

Install the batterty, battery tray and the air cleaner assembly.

Check for the starter motor when the ignition swith is at 'START' position and th shift lever at 'P' or 'N' range.

Check for the rear lamp when the ignition swith if it does not work porperly.

Check for the inhibiter switch if it does not work properly.

If the inhibiter switch is not fixed in a proper position, reassemble it in the right position.

Re-check 1 and 2 procedures.

Using a scan tool, confirm the DTCs.

Disconnect the battery (-) terminal and the inhibiter switch.

Check for continuity between terminals at the switch connector.

If there are not continuity between the terminals in the table above for each switch position, replace the inhibiter switch.