1.
Remove the sunroof motor after removing 3 screws and disconnect the 10P connector from the sunroof motor.
Remove the sunroof motor after removing 3 screws and disconnect the 10P connector from the sunroof motor.
Inspect the sunroof motor side connector while the battery voltage and ground are connected as below table.
Inspect the sunroof motor harness side, as shown in the chart.
Tester connection | Condition | Specified condition |
3-Ground | IGN2 switch ON | Battery voltage |
1-Ground | Constant | Continuity |
6-Ground | Constant | Battery voltage |
