Remove all rust and contramination from the surface, and measure the disc thicness at 8points, at least, of seme distance (5mm) front the brake disc outer circle.
Front brake disc thickness
Except the Europe
Standard value : 26.0mm(1.024 in)
Limit : 24.4mm(0.961 in.)
In case of Europe
Standard value : 28.0mm(1.102 in)
Limit : 26.4mm(1.039 in.)
Thickness variation should not exceed 0.005mm (0.0004 in.) (circumference) and 0.01mm ( in.)(radius) at any directions.
If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.
Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.
Pad thickness
Standard value : 11.0 mm (0.43 in.)
Service limit : 2.0 mm (0.0787 in.)
Check that grease is applied, and the pad and backing metal for damage.
Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the run out of the disc.
Brake disc run out
Limit : 0.03 mm (0.0012 in.) or less
If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out again.
If the run out does not exceed the limit specification, install the brake disc after turning it 180° and then check the run out of the brake disc again.
If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.
