4.
Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Grease the threads of the adjuster assembly, turn the adjuster bolt (C), adjusting the length of the shoe ajuster assembly.
Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does contact the paint. Wash it off immediately with water.
To prevent spills, cover the hose joints with rags or shop towels.
Use only a genuine wheel cylinder special bolt.
Apply sealant (C) between the wheel cylinder (A) and backing plate (B), and install the wheel cylinder.
Connect the brake tubes (D) to the wheel cylinder.
Connect the parking brake cable to the parking brake lever.
Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Grease the threads of the adjuster assembly, turn the adjuster bolt (C), adjusting the length of the shoe ajuster assembly.
Hook the shoe adjuster spring (D) to the adjuster lever first, then to the brake shoe.
Install the shoe adjuster assembly and upper return spring (E), noting the installation direction. Be careful not to damage the wheel cylinder dust covers.
Install the lower return spring (F).
Grease brake cylinder to the sliding surfaces as shown below. Wipe off any excess. Don't get grease on the brake linings.
Grease brake cylinder to the brake shoe ends and opposite edges of the as shoes as shown below.
Wipe off any excess. Don't get grease on the brake linings.
Grease brake shoes (A) onto the backing plate. Be careful not to damage the wheel cylinder dust covers.
Install the shoe hold down pins (B) and the shoe hold down washers (C).
Install the upper return spring (D).
Install the brake drum.
Bleed the brake system,after refilling the brake fluid.
Depress the brake pedal several times to set the self-adjusting brake.
Adjust the parking brake.
