2.
Remove the front door speaker after removing 4 screws.
Remove the front door trim panel (see BD group - front door).
Remove the front door speaker after removing 4 screws.
Installation is the reverse of removal.
Remove the rear door trim panel (see BD group - rear door).
Remove the rear door speaker after removing 4 screws.
Installation is the reverse of removal.
Remove the delta cover from the front door then disconnect the 2P connector.
Remove the tweeter speaker(A).
Installation is the reverse of removal.
Remove the passenger side seat (see BD group - front seats)
Remove the woofer speaker(A) from the passenger side floor after removing 2 bolts and 2 nuts.
Installation is the reverse of removal.
Open the tailgate then remove the luggage floor mat and trim.
Remove the external amp(A) from the luggage right side floor.
Installation is the reverse of removal.
Troubleshooting for Speaker
Basic inspection of speaker
Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts.
Case Troubleshooting
No. | Case | Inspection/Remedy |
1 | Trembling sound | 1. Before replacing the speaker, inspect that the mounting screw is installed normally. 2. After re-installing the speaker, verify that no trembling sound is heard. 3. When hearing a trembling sound again, replace the speaker with new one. |
2 | Noise | 1. Check if the wiring connector is connected normally. If not, reconnect the wiring connector. 2. In case of radio static, check if there is a noise from CD. 3. When a noise is heard on turning radio and CD on, replace the speaker with new one. note In case there is only radio static, this causes from poor radio reception. Thus the speaker needs no repair and replacement. |
3 | Poor working | Inspection of the wiring connection between the battery and the speaker 1. Before replacing the speaker, inspect the wiring connection between the battery and the speaker is normal. 2. Check the supplying power to the speaker and the resistance, then inspect the sound quality. ■ Specified impedance : 2 ~ 4Ω  3. If the speaker works poorly, replace it with new one. |
During dealing of speaker
Do not damage the speaker with impact as like a drop and a throw.
Be careful not to cover water and oil over the speaker.
Caution during dealing of speaker because the material of diaphragm is paper which is easy to be torn by impact and external force.
When modifying audio system as customer pleases, this does electric damage to speaker.
And, in this case the speakers are not covered by the manufacturer's warranty.
